VViViD+ Gloss Metallic Chameleon Blue to Purple Color-Shift (2ft x 5ft) with Air Release

Purchased this to wrap my Steamdeck instead of going through the painstaking task of a new shell. It was so easy and turned out perfect! Used my cricut to cut it out, and slowly used a heat gun to secure the fit. Will be buying more colors for other items around my house!

This is great stuff 3m ,great adhesive, color is on point 👉 👈. Using to wrap my downhill mtn bike frame

Used as a golf shaft wrap and it went on smoothly! If you're thinking of doing something similar, here's my process.Cut the vinyl to the proper size. for 45-47" driver, the butt end is 2" wide and the tip is 1.5". I measure the half way point at 1-3/4. Use a piece of painters tape wrapped around the shaft to ensure measurements will fit your shaft.If possible, roll the grip opening up over itself to access the shaft under the grip.Apply the shaft wrap at the butt end first; Centering the wrap with the upper side of the shaft. It doesnt matter that much as the wrap is nearly seamly when applied correctly. Press the wrap down the length of the shaft and back up. Work one side of the shaft till it is laid down smoothly around the back, then the other side in the same manner. Trim and excess from the tip end using a razor or sharp knife. Cut angle towards the ferrule and do not cut into your graphite shaft. If your shaft is steel, you have nothing to worry about on that front.Last thing, IMPORTANT! Make sure there arent any crinkles or bubbles BEFORE applying heat. I used a hair dryer set on high and went up and down the length of the shaft a few times, pressing the wrap firmly as I went around. When youre done, roll the grip back down.Wrap added 8gr to the shaft weight. Wrap does not affect playability or flex.

As you can see in the photo, I purchased this to cut a vinyl decal for my mobile tattoo studio. *I just cut and applied it yesterday so I can’t speak to the longevity yet, but the color shift is really great and exactly as pictured. It has just enough sparkle in it to flash but not enough to be gaudy and I like that it’s darker when out of the sunlight, making it easier to read at a distance. Because of the glossy texture I had some reservations about whether or not it would cut well on my Cricut, but I went for it and I’m glad I did because it cut perfectly and easily. It was about average to weed, not the easiest but not the worst I’ve dealt with either. Unfortunately, the transfer tape that I used was ridiculously sticky and made transferring tough. I was pleasantly surprised that throughout that process the vinyl didn’t tear at all and it was easily lifted off of the surface and placed again, while I got the alignment where I wanted it to be. It maintained a good stretch and applied easily despite the difficult time I had with the transfer tape. I’m sure if I had used tape with less grip, the process would have been simpler. All in all, I’m really happy with the quality and so far, after applying a medium amount of heat, the bond seems strong.*I’ll update this review as time goes on. I’m optimistic that this will last the 3-5 years that the manufacturer states, but time will tell.

Why did you pick this product vs others?:Loved the color and quality Adhesion:very sticky

Excelent

This applied seamlessly to a live edge acacia wooden coffee table. The quality is top notch, no bubbles and adhesion was perfect! The color gives and then some and it’s really a durable surface covering. I love that I discovered this vinyl, it’s so multi functional! At $11 buck per side, you can’t beat the value for your money! I highly recommend this for the DYI’ers out there! I will say the color pops best on items that are in a well lit area, as it shows the full spectrum of colors!

It’s a great looking product and the color pops immediately. It’s easy to work with as this my first time doing a wrap. It’s durable, easy to apply and reapply with just some heat and easy to remove bubbles. If you pre heat and post heat you should have no problems.