Draft Blocker 4'' Inch - Backdraft Damper - Draft Stopper - Backflow Preventer - Inline Fan Vent Deflector - One-Way Airflow Ducting - Dryer Duct Connector with Backdraught Flap

Living in the deep south, after installing a new kitchen exhaust fan the down-draft from the attic was overwhelming. Especially since kitchen exhaust fans are located right over the stove and it is canning season! This item is wonderful. There is no more down-draft at all and combined with my wonderful new exhaust fan my kitchen is comfortable again. At least as comfortable as it can be when I am canning in the summer time in the deep south ;) Great product, shipping time was fast, installation was easy. Thank you!

Had an issue with hot are back drafting through my bathroom exhaust vents during the summer time and cold air coming through in the winter time! These stopped that issue. Seal in the inside ensures unwanted air stays out of areas you don’t want it

This damper works, but the spring is very weak. If you tip it anywhere past horizontal the doors fall open, so it can only be installed with the doors facing up or horizontally. Additionally if the doors open all the way to the center, the springs are not strong enough to push them closed again. I haven't run into an issue with this yet, but just noticed during the installation and will need to check at some point to make sure they are not stuck open.

Well made and blocker plates (2 half moon pieces) pivot well for exhaust under lower pressures, and allows very minimal backdraft air to enter.

It is just what we needed to stop backdraft down our kitchen vent. It works great. Not really easy to install but since we were just beginning the install on our new vent hood, it was easier than a retrofit. Seems to work well. Can’t talk or sturdiness till we see how long it lasts.

The item that arrived was a Labeled ECOPRO brand 5in. Duct Damper and not a Repa Market branded 5'' Inch - Backdraft Damper. The big problem is that the ECOPRO has two springs an the metal flaps that are so strong that you really have to push a descent amount to have the flaps open and the Repa Market brand shows a single spring that is for both flaps and would allow the flaps to open or close with little effort. It is being returned as it is not the brand stated, or the product described. I will order the neverest® RK 5" Professional Backdraft Shutter Damper which uses only a single spring and is well made!

I bought a new house and the builders didn't install a damper so in the winter I could feel cold air coming in at my stove. This was easy to install just removed a spacer from the existing exhaust pipe and put this in. All the cold air stopped this is exactly what I was missing.

It came with a slight bent in the corner of the flap. It was easy enough to flatten back out so I was not that concerned. As can be seen in the second photo it is about 12.25 inches inside diameter. It’s actually a metric size. Since I had nothing that could take up that much space with crimps I actually put weather stripping around the collars I slipped inside and attached my screws through everything together being careful not to impede the dampers. It’s been in place 10 months and is still working ok. I ran a bead of caulk around the outside rim to seal it as best I could. It didn’t fit but I made it work. I seemed well made just not for 12in duct.